Your cart is currently empty
The Enerwatt EWC 148 Automatic battery charger has built in ultra-low power consumption circuit and operates with very high power efficiency.
This charger will automatically go into ECO mode when battery is disconnected.
Available in store
CloseSMART CHARGE PLUS MAINTENANCE AND REJUVENATION
Easy to Use: Easy to operate and requires no technical experience.
Fully controlled by Microprocessor
Battery initial condition diagnosis
Enhanced battery rejuvenation (patented technology)
Battery voltage retention analysis
Peak pulses for long term maintenance
Ultra lower power consumption ( ECO mode)Safety Protections
- Qualification - Battery condition check
- Battery rejuvenation
- Soft Start
- Bulk Charging
- Absorption Charging
- Voltage analysis
- Float Mode
- Long term maintenance pulse charge
Suits all Lead Acid Type Batteries. (GEL, WET, AGM, Pure Lead)
Adjustable charge rate: 12V volt battery
Deep Cycle (AH) |
Automotive (CCA) |
Marine (MCA) |
Time (Hours) |
|
1Amp |
7-20 |
40-120 |
55-165 |
7-24 |
4Amp |
30-80 |
180-480 |
250-650 |
7-24 |
8Amp |
60-160 |
360-1000 |
500-1300 |
7-24 |
INTERNAL OVERHEAT PROTECTION: The battery charger is built-in with overheat and overload electronic circuit. When the charger is overheated, the charger will decrease the charging current. If temperature is decreased, the charger will resume to normal charging.
TIMER PROTECTION: The charger provides the maximum charging timer management for each charging stage.
REVERSE POLARITY: The charger has reverse battery protection.
SHORT CIRCUIT PROTECTION: The charger has output short-circuit protection.
Once the charger detects the output short-circuit or reverse polarity, it will not deliver any output current.
Brand
Enerwatt
Warranty
Weight (kg)
1.2000
LED display of the state of charge and selected options.
- Protection against reversed polarity, overload and short-circuit.
- 2 types of connectors included: clamps and eyelets.
- Corrosion resistant.
The EWC12-148 fully automatic high frequency charger features a microprocessor which charges conventional 12V batteries (car, motorcycle), deep cycle (RV, boat), gel, AGM (electric bike) and pure lead batteries.
It has an easy to set interface with a selection of three charge levels: 1, 4 and 8 amperes and two optional charge modes to prolong the life of your battery: equalizing and conditioning.
A Rapid Charger That Prolongs The Life of Your Battery
The EWC12-148 is a pulse charger, it uses fast variations of high voltage (pulses), higher than the average constant load chargers.
Result: a faster charge, perfect every time, causes less evaporation than regular chargers, prolongs the life of your batteries and needs less maintenance.
Moreover, the conditioning mode reverses the accumulation of sulphates on the plates of the battery, which may give more power to an old battery.
For acid batteries, the equalization mode is used to level each cell of the battery for a balanced operation which optimizes performance.
Perfect For Charging In Storage
Perfect for the storage of batteries, it itself detects if batteries need charging or not. 100% safe and hassle free.
A Complete Intelligent Charger
Practical interchangeable cables for a permanent installation on a motorcycle or a deep cycle battery or for an easy connection when maintaining or storing batteries.
Product carousel items